|
Cutting Oil Filtration and Recycling
Why Use Cutting Oils?
Cutting oils are believed to act as a lubricant in the interface
between chips and the tool reducing friction and aiding in chip
flow. The primary reason for the use of cutting oils is for lubrication
to reduce process friction. Cutting oils are also employed to increase
the rate of heat flow from the machining process, i.e. for cooling
to remove any process generated heat. This lubrication and cooling
improves the surface finish of the machined work. Additionally,
the cutting oil is used to transport any chips away from the cutting
zone.
When using cutting oils you may experience any of the following:
• Unacceptable processed part
• Excess chips in the "cutting
zone"
• Increased process friction
• Elevation in process temperature
Solution: COMO Filtration Systems
Particulate contamination does not mean that the cutting oil must
be disposed of and replaced. Through multi-pass filtration, the
particulate can be removed from the cutting oil and thus the life
of the cutting oil can be increased. Both fine and gross contamination
can be removed through the use of multi-pass filtration. COMO
Filtration will reduce part cracking and distortions, help
reduce process friction and improve finish quality.
Please click on the model numbers to view more information on systems
that optimally perform cutting oil filtration. 4000,
120,
265
|
